TOMATECH AUTOMATION
104 G65 commands illegal H command
105 Macro variable number of G65 is illegal(error)
106 Macro variable P is not commanded or P value is zero in G65
107
Variable Q is not commanded or Q value is zero when H commands
except for H80 or H99 are commanded
108 Do not command variable R or R is illegal
109 P command value isn’t variable in G65
110 Number with H21 in G65 is negative
111 H99 user alarm number in G65 exceeds its range
112
Block number of macro command (G65)skip or M99 program return
exceeds their range
113 There is no block number for block skip or M99 program return
114 G65, G66 command format are mistaken
115 G65 H operand is mistaken
118 Number of argument I, J, K cannot exceed 10
120 The thread graduation heads are more than 65535
121 The spindle encode lines are not in 100--5000
130 Programmed axis name is invalid
131
G31/G32/G32.1/G33/G34/G46/G47/G84/G88/Y cannot be used to C tool
nose radius compensation
132 Additional axes have no chamfer function
133 Specified axis is a linearity of cylinder or rotary axis
134 Cannot specify the cylinder radius again
135
The linear or rotary axis setting used to the cylinder interpolation is
mistaken
Appendix
465
Appendix
No. Content Remark
136
Only currently use the tool nose direction T0 or T9 to create C tool
compensation
140 The macro format is specified in error
141 DO,END tabs are not 1,2,3 in macro statement
142 DO,END formats are specified in error
143
The brackets are not matched in macro statement or the format is
specified in error
144 The divisor in macro statement cannot be 0
145 The specified anti-tangent ATAN format is mistaken in macro statement
To Next Page
Loading...
Need help?
General