TOMATECH TAC-100XT User Manual

TOMATECH AUTOMATION
067 Flute quantity is more than 10
068
Starting point coordinates are abnormal when cycle ends and returns to
starting point
069 G76 tool nose angle is more than or equal to thread angle
081 Y cannot feed with X, Z
082
Have no the measured position arrival signal in parameter specifying area
in automatic tool offset(G36,G37)
083
Specifying an invalid axis or a command is incremental in automatic tool
offset (G36,G37). Modify the program
084
Have the measured position arrival signal in area set by the parameter in
automatic tool offset(G36,G37)
464
Appendix
No. Content Remark
085
The distance between the starting point and the target is less than the
setting (142,143) in automatic tool offset(G36,G37), have no set the rapid
motion area
086
The parameter (142,144) or (143,145) area setting are wrong in automatic
tool offset(G36,G37)
087 Firstly create or set the coordinate system before executing G36,G37
088
Firstly set the correct tool number and the compensation number before
executingG36,G37
089 The tool offset is in protection state, and cannot be written
090 When tool offset measure executes the direction input B operation, axis
movement directions are interlocked
095 Subprogram numbers are not input or are illegal when M98 calls them
096 Layers of nested subprograms are more than 4
097 Calling programs in M98 is the current one(main program)
098 Use M98 or M99 in MDI mode
099 Use M98 or M99 in C tool radius compensation
100
Cannot use macro statement and macro command in C tool radius
compensation
101 Operation values of H11, H12, H13, H25 are not binary in G65
102 Operation value of H24 is more than 1023 in G65
103 Denominator is 0 for division operation in G65

TOMATECH TAC-100XT Specifications

General

Brand	TOMATECH
Model	TAC-100XT
Category	Control Systems
Language	English