TOMATECH AUTOMATION
031 There is non-monotony of corresponding coordinates in G71~G73
032 Absolute value of R is more than that of U/2 in G90, G92
033 Absolute value of R is more than that of W in G94
034 There are more than 100 blocks in G70~G73
035 Ns and Nf are reversed each other in G70~G73
Appendix
463
Appendix
No. Content Remark
036 There is no Ns or Nf or they exceed their allowed range in G70~G73
037 There is no Ns or Nf in G70~G73
038 Single infeed exceeds its allowed range in G71 or G72
039 Single tool retraction exceeds its allowed range in G71 or G72
040 Total cutting travel exceeds its allowed range in G73
041 Cycle times is less than 1 or more than 99999 in G73
042 Single tool retraction R(e) exceeds its allowed range in G74 or G75
043 The tool retraction is negative at the end of cutting in G74 or G75
044 X/Z single cutting value exceeds its allowed range in G74 or G75
045
Starting point of cutting taper thread is between thread starting point and
its end point in G76
046 Min. cutting value exceeds its allowed range in G76
047 Finishing allowance exceeds its allowed range in G76
048 Tooth height is less than finishing allowance or 0 in G76
049 Cycle times exceeds its allowed range in G76
050 Chamfer exceeds its allowed range in G76
051 Angle of tool nose exceeds its allowed range in G76
052 X/Z movement distance in G76 is zero
053 There is no specified tooth height P in G76
054 There is no the first cutting depth Q or Q is 0 or Q is not input
055 Call subprograms in G70~G73
056 Ns does not command G00 or G01 in G70~G73
057 X/ Z value is not specified in the first block or the movement is 0 in G71
058 X/ Z value is not specified in the first block or the movement is 0 in G72
059 Z value is 0 or not input in G74
060 Q value is 0 or not input in G74
061 X value is 0 or not input in G75
062 P value is 0 or not input in G75
063 Initial blocks are employed with the forbidden G commands in G70~G73
064 End blocks are employed with the forbidden G commands in G70~G73
065 Execute G70~G73, G07.1, G12.1 in MDI mode
066
The cycle starting point is in the closed area formed by the starting point
and end point of the finishing path
To Next Page
Loading...
Need help?
General