TOMATECH AUTOMATION
mode, parameter switch ON and 3-level operation limit.
A. alter data:
In tool compensation -> tool life window, press to move the tool to the life position,
input directly data, such as 500, press to confirm the input. Press to
complete data input (tool offset, life) .
Ⅰ Programming
B. Inserting data:
Insert any serial number in the current page, press ――＞［01～08］――＞
,insert a new line, and the initial value definition is as follows:
Serial number Tool offset Life Used Mode State
a)Insert the front and the previous serial number moves backward
. Before insert
To Next Page
Loading...