Multi Pro 5800Page 6 − 34Electrical System
Advisory
Advisory Description Recommended Action
2 Start Prevented − Pump switch active Set spray pump enable switch to OFF
position
3 Start Prevented − Not in neutral Set traction pedal to neutral.
Adjust traction pedal for Neutral if
necessary (see Chapter 4 − Hydraulic
System in this manual)
4 Start Prevented − Operator not in seat Operator return to seat or set parking
brake
5 Start Prevented − Starter engage timeout Starter has been engaged for more
than 30 seconds
Allow starter to cool before
reattempting to start engine
6 Start Prevented − Rinse pump switch active
(optional clean rinse kit)
Set rinse pump enable switch to OFF
position
102 Engine Stopped − Operator not in seat Operator return to seat or set parking
brake
103 Driving with parking brake is engaged Disengage parking brake
202 Pump start prevented − Boom active Set master boom switch to OFF
position
203 Pump Start Prevented −
Operator out of seat and parking brake not engaged
Operator return to seat or set parking
brake
205 Pump Start Prevented − Engine starting Set spray pump enable switch to OFF
position
206 Pump Turned OFF − Operator not in seat Operator return to seat or set parking
brake
402 Tank Low Volume Alert Prepare to discontinue spraying as the
volume in the spray tank has dropper
below the alert level set by the user
403 Rinse Pump ON (optional clean tank rinse kit) Set optional clean tank rinse pump
switch to OFF position
502 Invalid Parameter Value Entered Only values within the defined
software parameters can be entered
by the user
503 Invalid Parameter Value Read from EPROM Possible TEC damage
Contact your Authorized Toro
Distributor
802 Booms Turned Off − Vehicle speed too low for automatic mode
function
Increase vehicle speed before at-
tempting ExcelaRate (automatic appli-
cation−rate) spray system control, or
switch to Manual spray system control
To Next Page
Loading...
Need help?
General
