Toro Multi Pro 5800 - Chapter 8 Geolink Spray System

Multi Pro 5800 Page 8 − 1 GeoLink Spray System
Chapter 8
GeoLink Spray System
Table of Contents
SPECIFICATIONS 2............................
GENERAL INFORMATION 3.....................
User Manuals 3..............................
GeoLink Spray System Service and Support 3....
Precautions Concerning Chemicals Used in
Spray System 3.............................
Precautions for Removing or Adjusting Spray
System Components 3.......................
GeoLink Terminology 4........................
SPECIAL TOOLS 5.............................
GEOLINK SPRAY SYSTEM DIAGRAM 6..........
GEOLINK SPRAY SYSTEM OPERATION 7........
GeoLink Components 8.......................
X25 AND X30 CONTROL CONSOLE SCREENS 11.
Operation Screen 11..........................
Setup Screen 23..............................
INFOCENTER DISPLAY 27......................
InfoCenter Display Screens 28.................
Splash Screen 29.............................
Operator’s Information 30......................
Main Menu 31................................
Settings 32...................................
Service 33...................................
Diagnostics 34...............................
About 38.....................................
TROUBLESHOOTING 39........................
Automatic Section Control Override 39..........
Remote Assistance (X30 Consoles Only) 40......
X25 or X30 Control Console Error Messages 41..
Crash Reports 41.............................
Guidance and Rate Management System 42.....
Operator Advisories (InfoCenter Display) 43......
Using the InfoCenter Display
for Troubleshooting 44.......................
Machine Fault (InfoCenter Display) 45...........
Product Handling System 46...................
ADJUSTMENTS 48.............................
Compass Calibration 48.......................
Flow Meter Calibration 49......................
SERVICE AND REPAIRS 51.....................
GPS Antenna (AGI−4) 51......................
Modem (machines with RTK correction) 52.......
Inertial Measurement Unit (IMU)
(machines with RTK correction) 53............
Automatic Section Controller (ASC−10) 54.......
X25 or X30 Control Console 56.................
Can−bus Terminator Resistors 58...............
Fuses 58....................................
Material Handling “Wet” Components 59.........
Spray Pump 60...............................
Spray Pump Service 64........................
Pressure Relief Valve 68.......................
Spray Control Manifold Assembly 70............
Agitation Valve Assembly 72...................
Nozzle Valve Assembly 74.....................
Nozzle Valve and Agitation Valve Service 76.....
Agitation Bypass Valve Service 77..............
Agitation Throttle Valve Service 78..............
Flow Meter 79................................
Flow Meter Service 80.........................
Suction Line 82...............................
Agitation Line 84..............................
Drain Line 86.................................
Turret Bodies 88..............................
Turret Body Service 90........................
Spray Boom Hinge 92.........................
Spray Tank 94................................
GeoLink
Spray System