Multi Pro 5800−G Page 4 − 3 Kubota Gasoline Engine
General Information
This Chapter gives information about specifications, ad-
justments and repair of the Kubota Gasoline engine that
powers the Multi Pro 5800−G.
Operator’s Manual
The Operator’s Manual provides information regarding
the operation, general maintenance and maintenance
intervals for the Kubota gasoline engine that powers
your Multi Pro 5800−G. Refer to that publication for
additional information when servicing the machine.
Kubota Workshop and Troubleshooting Manuals
General maintenance procedures are described in your
Operator’s Manual. Information on engine testing, dis-
assembly and reassembly is identified in the Kubota
Workshop Manual (WG1605 Series) that is included at
the end of this chapter. Information on engine trou-
bleshooting and testing is identified in the Kubota Diag-
nosis Manual (WG1605 Series) that is included at the
end of this chapter.
Most engine repairs and adjustments require tools
which are commonly available in many service shops.
Special tools are described in the Kubota Workshop
Manual EG1605 Series). The use of some specialized
test equipment is explained. However, the cost of the
test equipment and the specialized nature of some re-
pairs may dictate that the work be done at an engine re-
pair facility.
Kubota Gasoline Engine
The engine used in your Multi Pro 5800−G is a Kubota
WG1605 Series gasoline engine. Engine features in-
clude an electronic control module (ECM) that controls
a common rail fuel injection system with direct injection,
electronic throttle valve (ETV), an electronic governor
and a catalytic muffler exhaust system with oxygen sen-
sors. The ECM receives information from numerous en-
gine sensors. The information provided allows the
engine ECM to monitor and control engine operation for
optimum engine performance.
Figure 1
Kubota Gasoline
Engine
To Next Page
Loading...
Need help?
General
