Multi Pro 5800 Page 6 − 33 Electrical System
Operator Advisories
If one or more Toro Electronic Controller (TEC) inputs
are not in the correct position to allow certain machine
operations, or are malfunctioning, an audio alarm will
sound and an Operator advisory will appear on the Info-
Center Display (Fig. 39). Typically, an advisory can be
eliminated with a change in machine controls by the op-
erator. For example, if the operator attempts to start the
engine when the traction pedal is depressed, an adviso-
ry is identified on the InfoCenter Display that the traction
pedal needs to be in neutral. The advisory screen will
clear automatically after a few seconds or can be
cleared from the display manually by pressing any of the
InfoCenter buttons. An advisory will not be recorded in
any fault log. The following table explains each advisory
in more detail.
The InfoCenter Display is also used during the flow me-
ter Calibration and Speed Sensor Calibration process to
display a variety of instructions and advisories (see
Spray System Chapters in this manual for additional in-
formation).
In addition to Operator advisories, a machine fault may
occur during machine operation. The InfoCenter Dis-
play will display the current machine fault code and log
the specific fault information (see Faults Codes in this
chapter).
1. Advisory number/code 2. Advisory description
Figure 39
1
2
Electrical
System
To Next Page
Loading...
Need help?
General
