EasyManuals Logo

Toro Multi Pro 5800 Service Manual

Toro Multi Pro 5800
501 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
Multi Pro 5800−DPage 3 − 14Kubota Diesel Engine
13.Carefully lift radiator up and out of the machine.
14.Inspect radiator hoses and rubber iso−mounts. Re-
place worn or damaged components as necessary.
15.,Inspect foam radiator shroud seals and foam radia-
tor seals in machine frame. Replace any foam seals that
are damaged or deteriorated.
Installation
1. Position lower fan shroud below fan.
2. Carefully lower radiator into the machine. Secure
iso−mounts on the bottom of the radiator to the machine
frame with two (2) flange nuts.
3. Secure radiator to front radiator shroud and oil cooler
(Fig. 7 item 21) with six (6) cap screws (Fig. 7 items 22
and 23), lock washers and flat washers.
4. Secure upper fan shroud to lower fan shroud with
cap screws (Fig. 7 item 14), flat washers and flange
nuts.
5. Secure fan shroud assembly to radiator with four (4)
cap screws (Fig. 7 item13), lock washers and flat wash-
ers. Make sure that clearance exists between fan
shrouds and fan at all points before tightening fasteners.
6. Connect lower and upper radiator hoses to the radia-
tor. Secure hoses with hose clamps.
7. Carefully pivot console assembly back in position
taking care to not damage wire harness or throttle cable.
Install fasteners to secure console assembly to seat box
assembly (Fig. 6).
8. Secure both seat belt bracket assemblies to seat box
with carriage screws and flange nuts (Fig. 6).
9. Fit overflow hose to radiator flange and secure with
hose clamp. Make sure overflow hose is not kinked.
10.Fill radiator with coolant (see machine Operator’s
Manual)
11.Check position of electrical wires, hydraulic hoses
and control cables for proper clearance with rotating,
high temperature and moving components.
12.Start engine and check for proper operation. Check
all coolant hose connections for leaks.
13.Install the undercarriage shrouds to the machine
(see Undercarriage Shrouds in Chapter 9 − Chassis in
this manual).
14.Install the seats and hinged seat panels to the seat
box (see Seats in Chapter 9 − Chassis in this manual).

Table of Contents

Other manuals for Toro Multi Pro 5800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toro Multi Pro 5800 and is the answer not in the manual?

Toro Multi Pro 5800 Specifications

General IconGeneral
BrandToro
ModelMulti Pro 5800
CategoryPaint Sprayer
LanguageEnglish

Related product manuals