Multi Pro 5800Page 6 − 42Electrical System
Component Testing
For accurate resistance and/or continuity checks, elec-
trically disconnect the component being tested from the
circuit (e.g. disconnect the ignition switch connector be-
fore doing a continuity check on the ignition switch).
NOTE: For Multi Pro 5800−D machines, see the Kubo-
ta Workshop Manual (05−E3B Series) for engine com-
ponent testing information. For Multi Pro 5800−G
machines, see the Kubota Workshop or Diagnosis
Manual (WG1605−G−E3 Series) for engine component
testing information.
CAUTION
When testing electrical components for continu-
ity with a multimeter (ohms setting), make sure
that power to the circuit has been disconnected.
To Next Page
Loading...
