Multi Pro 5800 Page 6 − 95 Electrical System
Service and Repairs
NOTE: See the Kubota Workshop Manuals for engine
electrical component repair information.
Headlights
CAUTION
The headlights use a halogen bulb that becomes
extremely hot when in operation. Handling a hot
headlight bulb can cause severe burns and per-
sonal injury. Allow enough time for bulb to cool
before handling.
CAUTION
Any surface contamination can damage the
headlight bulb and lead to its failure or explosion
creating a serious safety hazard.
Headlight bulbs should be handled without
touching the clear bulb surface. Handle the bulb
by holding onto the base.
Headlight Disassembly (Fig. 151)
1. Park machine on a level surface, stop engine, apply
parking brake and remove key from ignition switch.
2. Access the headlight assembly from under the in-
strument panel on rear of hood and disconnect the wire
harness connector from the headlight bulb.
3. If bulb removal is necessary, loosen the bulb from the
headlight by rotating it 1/4 turn counter−clockwise.
Then, grasp bulb base and remove bulb from the head-
light. Do not touch the clear bulb surface when removing
bulb.
4. If necessary, remove headlight from machine.
A. Remove three (3) clips that secure headlight to
headlight brackets on rear of hood.
B. Remove headlight from machine.
1. Hood
2. Headlight assembly (2)
3. Halogen bulb
4. Clip (3)
Figure 151
1
2
3
4
Headlight Assembly (Fig. 151)
1. If headlight was removed, secure headlight to ma-
chine:
A. Insert headlight into hood opening. Make sure
that SPEAKER logo on headlight lens is at bottom.
B. Secure headlight to headlight brackets on rear of
hood with three (3) clips.
2. If bulb was removed from headlight, align tabs on
bulb with notches in headlight opening. Insert bulb into
back of headlight without touching the clear bulb sur-
face. Secure bulb to headlight by rotating it 1/4 turn
clockwise.
3. Connect the wire harness connector to the headlight.
Electrical
System
To Next Page
Loading...
Need help?
General
