Toro Multi Pro 5800 Service Manual

Multi Pro 5800 Page 6 − 45 Electrical System
Optional GeoLink spray system (10 amp) protects
the unswitched power supply circuit for the X25 or X30
console and the AGI−4 GPS antenna. The fuse is locat-
ed in the GeoLink wire harness near the battery.
Optional GeoLink spray system (50 amp) protects
the unswitched power supply circuit for the ASC−10
automatic section controller. The fuse is located in the
GeoLink wire harness near the battery.
Testing
Locate the fuse to be tested. Turn ignition switch to the
ON position (do not start engine). With the fuse installed
in the fuse block, use a multimeter to verify that 12 VDC
exists at both of the terminal test points on the fuse. If 12
VDC exists at one of the fuse test points but not at the
other, the fuse is faulty.
If necessary, make sure that ignition switch is OFF and
key is removed from switch. Remove fuse from fuse
block and check that fuse has continuity across the fuse
terminals.
Electrical
System

Toro Multi Pro 5800 Specifications

General

Brand	Toro
Model	Multi Pro 5800
Category	Paint Sprayer
Language	English