Multi Pro 5800−DPage 3 − 20Kubota Diesel Engine
10.Install fuse block to left side seat base panel.
11.Using labels placed during engine removal, attach
wire harness connections at glow plug controller (front
seat base panel) and relays (left side seat base panel.
12.Install engine shroud to back of seat base (Fig. 9).
13.Install spray tank (see Spray Tank in the Spray Sys-
tem chapters in this manual).
14.If previously removed, install the R.O.P.S. bar to the
machine.
15.Install exhaust system (see Exhaust System Instal-
lation in this chapter).
IMPORTANT: Any leaks in the air intake system will
cause serious engine damage. Make sure that all air
cleaner components are in good condition and are
properly secured during assembly.
16.Install air cleaner hoses to engine manifold and
R.O.P.S. bar (see Air Cleaner in this chapter). Make
sure that hose clamps are properly tightened.
17.Install the radiator (see Radiator in this chapter).
18.Install cable ties to secure the wiring harness, fuel
lines and hydraulic hoses to the engine assembly using
notes taken during engine removal.
19.Install the front fenders.
20.Install battery and battery tray to machine.
21.Properly fill the radiator with coolant (see machine
Operator’s Manual).
22.Check engine oil level and adjust if necessary.
23.Connect positive (+) and then negative (−) battery
cables to the battery.
24.Check position of wires, fuel lines, hydraulic hoses
and cables for proper clearance with rotating, high tem-
perature and moving components.
25.Start engine and check for proper operation. Check
all hose connections for leaks. Check engine speed.
To Next Page
Loading...
Need help?
General
