Multi Pro 5800 Page 8 − 37 GeoLink Spray System
FAULT VIEWER
Machine faults are generated by the Toro Electronic
Controller (TEC) to identify an electrical system mal-
function (fault) that occurs during machine or spray sys-
tem operation. When a spray system fault occurs, an
audible alarm will sound and the InfoCenter will display
information about the fault. Spray system faults can be
viewed via the InfoCenter Fault Viewer (Fig. 42). See
Machine Faults in this chapter for additional information
about specific spray system faults.
The fault viewer displays the following information about
a spray system fault:
CODE: fault code number
LAST: last time the fault occurred expressed in Key
ON hours
FIRST: first time the fault occurred expressed in Key
ON hours
NUM: number of times the fault has occurred
Scroll through the fault viewer screens by pressing but-
tons 1 or 2.
Return to the previous screen by pressing button 5
19 39.4 39.4 1
1. Button 1
2. Button 2
3. Button 3
4. Button 4
5. Button 5
6. Machine faults
Figure 42
1
2
3
4
5
6
GeoLink
Spray System
To Next Page
Loading...
