Multi Pro 5800 Page 8 − 87 GeoLink Spray System
Disassembly (Fig. 89)
IMPORTANT: Make sure to remove and neutralize
chemicals from tank and spray components before
disassembly. Wear protective clothing, chemical re-
sistant gloves and eye protection during repair.
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Label hoses to allow proper installation after repairs
are completed. Loosen hose clamps and remove hoses
from hose barbs that are to be disassembled.
3. Disassemble drain assembly as necessary. Discard
all removed O−rings and gaskets.
Assembly (Fig. 89)
NOTE: Replace, do not reuse gaskets and O−rings.
Coat O−rings and gaskets with vegetable oil or silicone
grease before installation to reduce damage during as-
sembly.
1. Replace all removed O−rings and gaskets and as-
semble drain line.
2. Using labels placed during disassembly, install
hoses to hose barbs and secure with hose clamps.
3. Make sure that drain valve is closed and secured to
sprayer.
4. Check spray system for leaks. Repair all leaks be-
fore returning the sprayer to service.
GeoLink
Spray System
To Next Page
Loading...
Need help?
General
