Toro Multi Pro 5800 Service Manual

Multi Pro 5800 Page 8 − 89 GeoLink Spray System
Removal (Fig. 90)
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves and eye protection during repair.
1. Park machine on a level surface, stop spray pump,
stop engine and engage parking brake. Remove key
from ignition switch.
2. Loosen hose clamp(s) and remove supply hose(s)
from turret body.
3. Remove flange nut (item 1) that secures turret body
to mount bracket and remove turret body from machine.
Installation (Fig. 90)
NOTE: The position of the hose barb on the turret body
determines the turret body’s location on the spray boom.
1. Position turret body to mount bracket on spray boom
and secure it in place with flange nut (item 1).
2. Install supply hose(s) to turret body. Tighten hose
clamp(s).
3. Check spray system for leaks. Repair all leaks be-
fore returning the sprayer to service.
GeoLink
Spray System

Toro Multi Pro 5800 Specifications

General

Brand	Toro
Model	Multi Pro 5800
Category	Paint Sprayer
Language	English