Yealink T40G

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
280
0 to 3 (for T40P/T40G/T23P/T23G)
0 to 2 (for T21(P) E2)
Default
Blank
Web UI
Settings->Dial Plan->Dial Now->Account
Parameter
phone_setting.dialnow_delay
<y0000000000xx>.cfg
Description
It configures the delay time (in seconds) for the dial now rule.
When entered numbers match the predefined dial now rule, the IP phone will
automatically dial out the entered number after the designated delay time.
If it is set to 0, the IP phone will automatically dial out the entered number
immediately.
Note: It works only if the values of the parameters “dialplan.digitmap.enable” and
“account.X.dialplan.digitmap.enable” are set to 0 (Disabled).
Permitted
Values
Integer from 0 to 14
Default
1
Web UI
Features->General Information->Time Out for Dial Now Rule
Parameter
dialplan_dialnow.url
<y0000000000xx>.cfg
Description
It configures the access URL of the dial now template file.
For customizing dial now template file, refer to Dial Now File Customization.
Note: It works only if the values of the parameters “dialplan.digitmap.enable” and
“account.X.dialplan.digitmap.enable” are set to 0 (Disabled).
Permitted
Values
String within 511 characters
Default
Blank
[1]
X is from 1 to 100.
Area Code Configuration
The following table lists the parameters you can use to configure area code.
Parameter
dialplan.area_code.code
<y0000000000xx>.cfg
Description
It configures the area code to be added before the entered numbers when dialing out.
Example:
dialplan.area_code.code = 0592
Note: The length of the entered number must be between the minimum length
configured by the parameter “dialplan.area_code.min_len” and the maximum length
configured by the parameter “dialplan.area_code.max_len”. It works only if the values