Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
284
“123.T” would match “12
3
”, “12
33
”, “12
333
”, “12
3333
”, and so on.
“x.T” would match an arbitrary number.
“[x*#+].T” would match an arbitrary character.
Note
: If the string ends with a dot (for example, 123.), a match will
occur immediately after inputting the characters before the dot (e.,
123) since the dot allows for zero occurrences of the preceding
construct. Therefore, we recommend you to add a letter “T” after the
dot (for example, 123.T) for inputting more characters.
The letter “R” indicates that certain matched strings are replaced.
Using a RRR syntax, you can replace the digits between the first two
R
s with the digits between the last two
R
s. Example:
“R12R234R” would replace 12 with 234.
The letter “:” in the angle bracket indicates that certain matched
strings are replaced. Using the <:> syntax, you can replace the digits
before the colon with the digits after the colon.
Example:
“<12:234>” would replace 12 with 234. It is the same with R12R234R.
The exclamation mark “!” can be used to prevent users from dialing
out specific numbers. It can only be put last in each string of the digit
map.
Example:
“235x!” would match “2351”, “2352”, “2353”, and so on. The number
starting with 235 will be blocked to dial out.
The comma “,” can be used as a separator to generate secondary dial
tone.
Example:
“<9,:55>xx”, after entering digit “9”, secondary dial tone plays and
you can complete the remaining two-digit number.
Note: The secondary dial tone can be customized. For more
information, refer to Tones.
The letter “A” indicates the account that is applied to the digit map.
You can use A alone or a combination of A and account ID (for
example, <A1>).
Example:
“123A”, the default account will be applied to the digit map.
“123<A2>”, the second account will be applied to the digit map.
Note: It is not applicable to the digit map on a per-line basis.
To Next Page
Loading...
Need help?
General
