Yealink T40G

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
334
Yealink IP phones also support call forward on code and off code to activate and deactivate server-side
call forward feature. They may vary on different servers.
Tip
You can set a DSS key as a Forward key, and specify a contact you want to forward the incoming calls to for
this key. For more information, refer to DSS Keys.
Topics
Call Forward in Phone Mode Configuration
Call Forward in Custom Mode Configuration
Call Forward in Phone Mode Configuration
The following table lists the parameters you can use to configure call forward in Phone mode.
Parameter
forward.always.enable
<y0000000000xx>.cfg
Description
It triggers the always forward feature to on or off on a phone basis.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and value of the
parameter “features.fwd_mode” is set to 0 (Phone) (except T19(P) E2 IP phones).
Permitted
Values
0-Off
1-On, incoming calls are forwarded to the destination number (configured by the
parameter “forward.always.target”) immediately.
Default
0
Web UI
Features->Forward&DND->Forward->Always Forward->On/Off
Phone UI
Menu->Features->Call Forward->Always Forward->Always Forward
Parameter
forward.always.target
<y0000000000xx>.cfg
Description
It configures the destination number of the always forward on a phone basis.
Note: It works only if “features.fwd.allow” and “forward.always.enable” are set to 1 and
value of the parameter “features.fwd_mode” is set to 0 (Phone) (except T19(P) E2 IP
phones).
Permitted
Values
String within 32 characters
Default
Blank
Web UI
Features->Forward&DND->Forward->Always Forward->Target
Phone UI
Menu->Features->Call Forward->Always Forward->Forward to
Parameter
forward.always.on_code
<y0000000000xx>.cfg
Description
It configures the always forward on code to activate the server-side always forward
feature.