Call Features
355
call when DND is activated. You can specify a priority that the incoming paging calls with higher or equal
priority are automatically answered, and the lower ones are ignored.
If it is disabled, all the incoming paging calls will be ignored when DND is activated in phone mode.
Topic
Multicast Paging Settings
Multicast Paging Settings Configuration
The following table lists the parameters you can use to change multicast paging settings.
It configures the codec for multicast paging.
Example:
multicast.codec = G722
Note: It is not applicable to T19(P) E2 IP phones.
Features->General Information->Multicast Codec
multicast.receive_priority.enable
It enables or disables the IP phone to handle the incoming multicast paging calls
when there is an active multicast paging call on the IP phone.
0-Disabled, the IP phone will ignore the incoming multicast paging calls when there is
an active multicast paging call on the IP phone.
1-Enabled, the IP phone will receive the incoming multicast paging call with a higher
priority and ignore the one with a lower priority.
Directory->Multicast IP->Paging Priority Active
multicast.receive_priority.priority
It configures the priority of the voice call (a normal phone call rather than a multicast
paging call) in progress.
1 is the highest priority, 31 is the lowest priority.
0-Disabled, all incoming multicast paging calls will be automatically ignored when a
voice call is in progress.
1-1
2-2
To Next Page
Loading...
