Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
400
Settings->Voice Monitoring->Period for Interval Report
phone_setting.vq_rtcpxr_moslq_threshold_warning
It configures the threshold value of listening MOS score (MOS-LQ) multiplied by 10.
The threshold value of MOS-LQ causes the phone to send a warning alert quality
report to the central report collector.
For example, a configured value of 35 corresponds to the MOS score 3.5. When the
MOS-LQ value computed by the phone is less than or equal to 3.5, the phone will
send a warning alert quality report to the central report collector. When the MOS-LQ
value computed by the phone is greater than 3.5, the phone will not send a warning
alert quality report to the central report collector.
If it is set to blank, warning alerts are not generated due to MOS-LQ.
Settings->Voice Monitoring->Warning threshold for Moslq
phone_setting.vq_rtcpxr_moslq_threshold_critical
It configures the threshold value of listening MOS score (MOS-LQ) multiplied by 10.
The threshold value of MOS-LQ causes the phone to send a critical alert quality report
to the central report collector.
For example, a configured value of 28 corresponds to the MOS score 2.8. When the
MOS-LQ value computed by the phone is less than or equal to 2.8, the phone will
send a critical alert quality report to the central report collector. When the MOS-LQ
value computed by the phone is greater than 2.8, the phone will not send a critical
alert quality report to the central report collector.
If it is set to blank, critical alerts are not generated due to MOS-LQ.
Settings->Voice Monitoring->Critical threshold for Moslq
phone_setting.vq_rtcpxr_delay_threshold_warning
It configures the threshold value of one way delay (in milliseconds) that causes the
phone to send a warning alert quality report to the central report collector.
For example, if it is set to 500, when the value of one way delay computed by the
To Next Page
Loading...
Need help?
General
