Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
452
<dialog id="0000"><state>terminated</state></dialog>
</dialog-info>
BLF List Subscription
When you configure the IP phone to monitor a list of specific remote lines, the IP phone sends a
SUBSCRIBE request with Request-URI containing the BLF List URI, and then receives a NOTIFY request.
The NOTIFY message contains XML body with status of each monitor line.
The following example shows a NOTIFY message for a BLF List, the BLF List contains 4605 and 4607:
<?xml version="1.0" <?xml version="1.0"?>
<list xmlns="urn:ietf:params:xml:ns:rlmi" xmlns="urn:ietf:params:xml:ns:rlmi" version="0"
fullState="true">
<resource uri="sip:4605@pbx.yealink.com">
<name>4605 Yealink</name>
<instance id="JQZxud2qeo" state="active" cid="8y35ri@broadworks"/>
</resource>
<resource uri="sip:4605@pbx.yealink.com">
<name>4605 Yealink</name>
<instance id="pXHQ97tPyQ" state="active" cid="tYzwJM@broadworks"/>
</resource>
</list>
Topic
BLF/BLF List Subscription Configuration
BLF/BLF List Subscription Configuration
The following table lists the parameters you can use to configure BLF/BLF List subscription.
account.X.blf.subscribe_period
[1]
It configures the period (in seconds) of the BLF subscription.
The IP phone is able to successfully refresh the SUBSCRIBE before the SUBSCRIBE
dialog expired.
Note: It is not applicable to T19(P) E2 IP phones.
Integer from 30 to 2147483647
Account->Advanced->Subscribe Period(Seconds)
account.X.blf.subscribe_event
[1]
It configures the event of the BLF subscription.
Note: It is not applicable to T19(P) E2 IP phones.