Yealink T40G

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
464
1000ms and then turns to white.
Note: It works only if “blf.enhanced.callout.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
Permitted
Values
String
Default
Blank
Parameter
blf.enhanced.callout.callin.action
<y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is
ringing and monitored user is calling out.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.callout.callin.action = newcall
Note: It works only if “blf.enhanced.callout.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
Permitted
Values
String
Default
Blank
Parameter
blf.enhanced.callout.talking.action
<y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is
talking and monitored user is calling out.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.callout.talking.action = newcall
Note: It works only if “blf.enhanced.callout.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
Permitted
Values
String
Default
Blank
Parameter
blf.enhanced.callout.idle.action
<y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is idle
and monitored user is calling out.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.callout.idle.action = newcall
Note: It works only if “blf.enhanced.callout.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.