Yealink T40G Administrator's Guide

Advanced Features
465
Permitted
Values
String
Default
Blank
BLF Key LED/Icon and Behavior for Talking State Configuration
The following table lists the parameters you can use to configure BLF key LED/icon and Behavior for
talking state (the monitored user is talking).
Parameter
blf.enhanced.talking.enable
<y0000000000xx>.cfg
Description
It enables or disables the custom configuration when the monitored user is talking.
Note: It is not applicable to T19(P) E2 IP phones.
Permitted
Values
0-Disabled
1-Enabled, the IP phone will display the custom BLF/BLF List DSS key LED status/icon
colors and perform the custom behavior when pressing the BLF/BLF List DSS key.
Default
0
Parameter
blf.enhanced.talking.led
<y0000000000xx>.cfg
Description
It configures the custom BLF/BLF List DSS key LED status/icon colors when the
monitored user is talking.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.talking.led = $LEDg1000o$
For
T54S/T52S/T46G/T46S/T42G/T42S/T41P/T41S/T40P/T40G/T29G/T27P/T27G/T23P/T23
G/T21(P) E2 IP phones, the BLF/BLF list DSS key LED glows green for 1000ms and then
goes out.
For T48G/T48S IP phones, the BLF/BLF List DSS key field displays a green icon for
1000ms and then turns to white.
Note: It works only if “blf.enhanced.talking.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
Permitted
Values
String
Default
Blank
Parameter
blf.enhanced.talking.callin.action
<y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is
ringing and monitored user is talking.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:

Yealink T40G Specifications

General

SIP Accounts	3
Wall Mountable	Yes
Opus Codec	No
Display	2.3 inch 132x64-pixel graphical LCD
Network	Dual-port Gigabit Ethernet
PoE	Yes
Headset Support	Yes, RJ9 port
Power Adapter	Optional
Voice Codecs	G.722, G.711(A/μ), G.729AB, G.726
Local Phonebook	1000 entries