Yealink T40G Administrator's Guide

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
466
blf.enhanced.talking.callin.action = newcall
Note: It works only if “blf.enhanced.talking.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
Permitted
Values
String
Default
Blank
Parameter
blf.enhanced.talking.talking.action
<y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor and
monitored user are talking.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.talking.talking.action = newcall
Note: It works only if “blf.enhanced.talking.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
Permitted
Values
String
Default
Blank
Parameter
blf.enhanced.talking.idle.action
<y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is idle
and monitored user is talking.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.talking.idle.action = newcall
Note: It works only if “blf.enhanced.talking.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
Permitted
Values
String
Default
Blank
BLF Key LED/Icon and Behavior for Parked-Against State Configuration
The following table lists the parameters you can use to configure BLF key LED/icon and Behavior for
parked-against state (a call is being parked against the monitored phone).
Parameter
blf.enhanced.parked.enable
<y0000000000xx>.cfg
Description
It enables or disables the custom configuration when a call is parked against the
monitored phone.

Yealink T40G Specifications

General

SIP Accounts	3
Wall Mountable	Yes
Opus Codec	No
Display	2.3 inch 132x64-pixel graphical LCD
Network	Dual-port Gigabit Ethernet
PoE	Yes
Headset Support	Yes, RJ9 port
Power Adapter	Optional
Voice Codecs	G.722, G.711(A/μ), G.729AB, G.726
Local Phonebook	1000 entries