Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
78
provisioning at the starting time.
If it is set to a specific value greater than starting time configured by the parameter
“static.auto_provision.weekly.begin_time”, the IP phone will perform auto provisioning
at random between the starting time and ending time.
If it is set to a specific value less than starting time configured by the parameter
“static.auto_provision.weekly.begin_time”, the IP phone will perform auto provisioning
at random between the starting time on that day and ending time in the next day.
Note: It works only if “static.auto_provision.flexible.enable” is set to 1 (On).
Settings->Auto Provision->Flexible Time
static.auto_provision.prompt.enable
It enables or disables the IP phone to prompt you for the configuration update and
the result (if any configuration changes) during auto provisioning.
Note: If the IP phone performs auto provisioning when receiving a SIP NOTIFY
message which contains the header “Event: check-sync”, the IP phone will display the
prompt message no matter whether the configuration is updated.
static.auto_provision.connect.keep_alive
It enables or disables the long connection for downloading files via auto provisioning.
0-Disabled, the IP phone uses short connection for downloading files via auto
provisioning
1-Enabled
[1]
If you change this parameter, the IP phone will reboot to make the change take effect.
User-Triggered Provisioning Settings Configuration
You can enable the users to trigger IP phones to perform provisioning by dialing an activation code. This
method works only if there is no registered account on the IP phone.
The following table lists the parameters you can use to configure settings for user-triggered provisioning.
static.autoprovision.X.name
[1][2]
It configures the code name to trigger auto provisioning.
To Next Page
Loading...
Need help?
General
