5-40
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Creating a Method
9Click Check Parameters.
This is to make sure that you haven’t made any major errors, such as forgetting to
select some of the masses to be acquired, etc. If there are no errors in the method, a
dialog box will pop up to indicate so. If there is an error, then some description
telling you what the mistake is will pop up. Click OK on the pop up box.
10 Click OK.
All data acquisition parameters are set as you edited. The screen goes on to
Peristaltic Pump Program, explained later in this chapter.
To Next Page
Loading...
