9-25
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Viewing Spectra
Proceed to step 5).
3) To set a specific value for the current sample, select the Set Specific Value radio
button.
4) Set the concentration in the Conc field in the Current ISTD Conc table.
The Current ISTD Conc table shows the internal standard currently set for
calibration. Click on the Conc field and enter a concentration level.
Click the right mouse button to display the popup menu, which allows you to copy,
paste, or delete the field.
Click Browse to set the concentration setting for each calibration level in the
Concentration field.
5) Click OK.
The Set ISTD Conc dialog box will close and the internal standard concentration
level will be set in the Edit Header dialog box.
If the Select a Calibration Level radio button was selected, the level number will be
displayed. If the Set Specific Value radio button was selected, “Manual” will be
displayed.
NOTE If your QC configuration does not include any QC parameters, the Sample Type
section will be grayed out.
5 Click the Update button.
The dialog box disappears and the new information will be updated (e.g. if you
change the dilution factor here, it will be reflected in the reports you generate).
NOTE You can display the Header information on the screen by simply clicking the Print
push button in this dialog box. If you want to print it on the printer, select
Data File>>Print.
To Next Page
Loading...
Need help?
General
