18-18
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Installing the Agilent 7500 ChemStation Software (Windows XP)
NOTE After installing the ChemStation software, you must set the same IP address in the
ICP-MS Configuration Window as set in the Bootp configuration window.
NOTE The Host Name must be entered.
Host name is restricted to the following characters only:
alphabet (A-Z), digits (0-9), and hyphen (-).
No distinction is made between upper and lower case. The first character must be an
alpha character. The last character must not be a hyphen.
8 If a paper notification of the MAC Address is not attached, complete the
following steps to get the MAC Address.
1 Select Maintain bootp tabfile?.
2 Select Do you want to log bootp requests?. Keep the displayed location of the
Bootplog File Location.
3 Enter the Subnet mask (255.255.255.0).
The value specific
to your ICP-MS.
To Next Page
Loading...
Need help?
General
