18-20
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Installing the Agilent 7500 ChemStation Software (Windows XP)
and the Subnet mask. Refer to the earlier steps.
11 After setting, return to the Bootp Settings. Remove check at Do you want to log
bootp requests?.
9Close the Bootp Settings.
10 Reboot the computer.
NOTE Reboot the computer after changing the Bootp Settings.
NOTE If you connect the instrument to the local network, you will need to talk with the
network administrator. You may want to call your local ICP-MS tech support team
for additional assistance.
To connect to site LAN, you are expected to understand the Windows XP operating
system and TCP/IP networking, such as host name, IP address, subnet mask settings.
You should also be familiar with the particular hardware devices and configurations
of your organization's local area network.
Agilent Technologies is not responsible for any software problems, LAN
configuration conflicts or performance problems that may result when a system is
connected to a non-isolated LAN.
To Next Page
Loading...
Need help?
General
