Agilent Technologies EXA N9010A - Page 50

49
Compatible SCPI Commands
SCPI Summary Table
MMEMory:SELect[:ITEM]:DEFault FSE/FSP/FSU Accepted
MMEMory:COMMent <string> FSE/FSP/FSU Accepted
[SENSe<1|2>:]AVERage:COUNt 0 to 32767 FSE/FSP/FSU Yes Max = 10000
[SENSe<1|2>:]AVERage[:STATe<1 to 3>] ON |
OFF
FSE/FSP/FSU Yes
[SENSe<1|2>:]AVERage:TYPE VIDeo | LINear FSP/FSU Yes
[SENSe<1|2>:]BANDwidth|BWIDth[:RESolutio
n] <numeric_value>
FSE/FSP/FSU Yes Min = 1 Hz
Max = 8 MHz
[SENSe<1|2>:]BANDwidth|BWIDth[:RESolutio
n]:AUTO ON | OFF
FSE/FSP/FSU Yes
[SENSe<1|2>:]BANDwidth|BWIDth[:RESolutio
n]:RATio 0.0001 to 1
FSE/FSP/FSU Yes
[SENSe<1|2>:]BANDwidth|BWIDth[:RESolutio
n]:TYPE NORMal | FFT | CFILter | RRC
FSP/FSU Yes
[SENSe<1|2>:]BANDwidth|BWIDth:VIDeo 1Hz
to 10MHz
FSE/FSP/FSU Yes Max = 50 MHz
[SENSe<1|2>:]BANDwidth|BWIDth:VIDeo:AU
TO ON | OFF
FSE/FSP/FSU Yes
[SENSe<1|2>:]BANDwidth|BWIDth:VIDeo:RAT
io 0.01 to 1000
FSP/FSU Yes
[SENSe<1|2>:]CORRection:EGAin:INPut[:MAG
Nitude] –200...200dB
FSP/FSU Yes Min = –81.90 dB
Max = 81.90 dB
[SENSe<1|2>:]CORRection:TRANsducer:SELec
t <name>
FSP/FSU Yes
[SENSe<1|2>:]CORRection:TRANsducer:UNIT
<string>
FSP/FSU Accepted Preset to DB
[SENSe<1|2>:]CORRection:TRANsducer:SCALi
ng LINear | LOGarithmic
FSP/FSU Yes
[SENSe<1|2>:]CORRection:TRANsducer:COM
Ment <string>
FSP/FSU Yes
[SENSe<1|2>:]CORRection:TRANsducer:DATA
<freq>,<level>..
FSP/FSU Yes All parameters are
dimensionless
[[SENSe<1|2>:]CORRection:TRANsducer[:STA
Te] ON | OFF
FSP/FSU Yes
Table 3-1 SCPI Commands Summary Table
SCPI Command Corresponding
Model
Support Notes
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html