50
Compatible SCPI Commands
SCPI Summary Table
[SENSe<1|2>:]CORRection:TRANsducer:DELet
e
FSP/FSU Yes
[SENSe<1|2>:]CORRection:TRANsducer:VIEW
ON | OFF
FSP/FSU Yes
[SENSe<1|2>:]DETector<1..3>[:FUNCtion]
APEak | NEGative | POSitive | SAMPle | RMS
|AVERage | QPEak
FSE/FSP/FSU Yes
[SENSe<1|2>:]DETector<1 to
3>[:FUNCtion]:AUTO ON | OFF
FSE/FSP/FSU Yes
[SENSe<1|2>:]FREQuency:CENTer 0 to fmax FSE/FSP/FSU Yes The value of fmax depends
on the analyzer hardware.
[SENSe<1|2>:]FREQuency:CENTer:STEP 0 to
fmax
FSE/FSP/FSU Yes
[SENSe<1|2>:]FREQuency:CENTer:STEP:LINK
SPAN | RBW | OFF
FSE/FSP/FSU Yes
[SENSe<1|2>:]FREQuency:CENTer:STEP:LINK
:FACTor 1 to 100 PCT
FSE/FSP/FSU Yes
[SENSe<1|2>:]FREQuency:SPAN 0 to fmax FSE/FSP/FSU Yes
[SENSe<1|2>:]FREQuency:SPAN:FULL FSE/FSP/FSU Yes
[SENSe<1|2>:]FREQuency:STARt 0 to fmax FSE/FSP/FSU Yes
[SENSe<1|2>:]FREQuency:STOP 0 to fmax FSE/FSP/FSU Yes
[SENSe<1|2>:]FREQuency:MODE CW | FIXed |
SWEep
FSE/FSP/FSU Yes
[SENSe<1|2>:]FREQuency:OFFSet FSE/FSP/FSU Yes
[SENSe<1|2>:]POWer:ACHannel:SPACing:CHA
Nnel 100 Hz to 2000 MHz
FSE/FSP/FSU Yes
[SENSe<1|2>:]POWer:ACHannel:SPACing:ACH
annel 100 Hz to 2000 MHz
FSE/FSP/FSU Yes
[SENSe<1|2>:]POWer:ACHannel:SPACing:ALT
ernate<1|2> 100 Hz to 2000 MHz
FSE/FSP/FSU Yes
[SENSe<1|2>:]POWer:ACHannel:TXCHannel:C
OUNt 1 | 2 | 3 | 4
FSP/FSU Yes
[SENSe<1|2>:]POWer:ACHannel:ACPairs 0 | 1 |
2 | 3
FSE/FSP/FSU Yes
Table 3-1 SCPI Commands Summary Table
SCPI Command Corresponding
Model
Support Notes
To Next Page
Loading...
