Agilent Technologies EXA N9010A - Page 52

51
Compatible SCPI Commands
SCPI Summary Table
[SENSe<1|2>:]POWer:ACHannel:BANDwidth|B
WIDth[:CHANnel] 100 Hz to 1000 MHz
FSE/FSP/FSU Yes
[SENSe<1|2>:]POWer:ACHannel:BANDwidth|B
WIDth:ACHannel 100Hz–1000MHz
FSE/FSP/FSU Yes
[SENSe<1|2>:]POWer:ACHannel:BANDwidth|B
WIDth:ALTernate<1|2> 100 Hz to 1000 MHz
FSP/FSU Yes
[SENSe<1|2>:]POWer:ACHannel:MODE
ABSolute | RELative
FSE/FSP/FSU Yes
[SENSe<1|2>:]POWer:ACHannel:REFerence:AU
TO ONCE
FSE/FSP/FSU Accepted
SENSe<1|2>:]POWer:ACHannel:REFerence:TX
CHannel:AUTO MINimum | MAXimum |
LHIGhest
FSP/FSU Yes
[SENSe<1|2>:]POWer:ACHannel:REFerence:TX
CHannel:MANual 1 | 2 | 3 | 4
FSP/FSU Yes
[SENSe<1|2>:]POWer:ACHannel:PRESet
ACPower | CPOWer | MCACpower |
OBANdwidth | OBWidth | CN | CN0
FSE/FSP/FSU Yes
[SENSe<1|2>:]POWer:ACHannel:PRESet:RLEV
el
FSP/FSU Accepted
[SENSe<1|2>:]POWer:BANDwidth|BWIDth 10
to 99.9PCT
FSP/FSU Yes
[SENSe<1|2>:]POWer:HSPeed ON | OFF FSP/FSU Yes
[SENSe<1|2>:]POWer:NCORrection ON | OFF FSP/FSU Yes
[SENSe<1|2>:]POWer:TRACe 1 to 3 FSP/FSU Accepted
[SENSe<1|2>:]ROSCillator:SOURce INTernal |
EXTernal
FSE/FSP/FSU Yes
[SENSe<1|2>:]SWEep:TIME 2.5ms to 16000s
(frequency domain) | 1us to 16000s (time domain)
FSE/FSP/FSU Yes
[SENSe<1|2>:]SWEep:TIME:AUTO ON | OFF FSE/FSP/FSU Yes
[SENSe<1|2>:]SWEep:COUNt 0 to 32767 FSE/FSP/FSU Yes Max = 10000
[SENSe<1|2>:]SWEep:EGATe ON | OFF FSE/FSP/FSU Yes
[SENSe<1|2>:]SWEep:EGATe:TYPE LEVel |
EDGE
FSE/FSP/FSU Yes
Table 3-1 SCPI Commands Summary Table
SCPI Command Corresponding
Model
Support Notes
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html