53
Compatible SCPI Commands
SCPI Summary Table
SYSTem:COMMunicate:GPIB[:SELF]:RTERmi
nator LFEOI|EOI
FSE/FSP/FSU Accepted
SYSTem:DATE FSE/FSP/FSU Yes Date display format is, for
example, 2010,5,10
SYSTem:DISPlay:FPANel ON | OFF FSP/FSU Yes
SYSTem:DISPlay:UPDate FSE/FSP/FSU Accepted
SYSTem:ERRor? FSE/FSP/FSU Yes
SYSTem:ERRor:LIST? FSP/FSU Accepted
SYSTem:ERRor:CLEar:ALL FSP/FSU Accepted
SYSTem:PRESet FSE/FSP/FSU Yes
SYSTem:TIME FSE/FSP/FSU Yes
SYSTem:VERSion
FSE/FSP/FSU Yes
TRACe<1|2>[:DATA] TRACE1 | TRACE2 |
TRACE3 | SPURious | ABITstream | PWCDp |
CTABle, <block> | <numeric_value>
FSE/FSP/FSU Yes Support the parameter list
as:
TRACe[1][:DATA]
TRACE1|TRACE2|TRACE3|
TRACE4|TRACE5|TRACE6,
<data>
where <data> can be
ASCII, REAL or INTeger.
TRACe<1|2>:IQ:DATA FSP/FSU Yes
TRACe<1|2>:IQ:SET <filter
type>,<rbw>,<sample rate>,<trigger
source>,<trigger slope>,<pretrigger samples>,<#
of samples>
FSP/FSU Yes
TRACe<1|2>:IQ:SRATe 15.625kHz to 32MHz FSP/FSU Yes
TRACe:IQ:STATe ON | OFF FSP/FSU Yes
TRIGger<1|2>[:SEQuence]:SOURce FSE/FSP/FSU Yes The following source
selections are not
supported: IFPower, TV,
AF, FM, AM and PM.
TRIGger<1|2>[:SEQuence]:LEVel:IFPower –30
to –10DBM
FSP/FSU Accepted
TRIGger<1|2>[:SEQuence]:LEVel:RFPower
<real>
FSP/FSU Yes Min = –200 dBm
Max = 100 dBm
Table 3-1 SCPI Commands Summary Table
SCPI Command Corresponding
Model
Support Notes
To Next Page
Loading...
