Allied Telesis SwitchBlade x3100 Series - Add Sntp Server

Configuring SNTP Introduction
1-77
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
ADD SNTP SERVER
Syntax
ADD SNTP SERVER={ipaddress|hostname}
Description Inputs the hostname or IP address of the SNTP server that the SBx3112 will use. If an
SNTP server is already specified, the command is rejected. To change the server, the
existing server must be deleted using the DELETE SNTP SERVER command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
officer SEC>> add sntp server 192.43.244.18.
Info (010017): Operation Successful
officer SEC>> sh sntp
-------------------------------------------------------------------------------
SNTP Configuration
------------------------------------------------------------------------------
Status On
Local IP 10.52.70.13
Last Update 2009-11-07 11:02:22 DST
Last Delta +00.00s
Last Status
Unknown error
SNTP Server
------------------------------------------------------------------------------
192.43.244.18
SNTP Statistics
------------------------------------------------------------------------------
Requests Sent 2
Responses Received 2
----------------------------------------------------------------------
Option Description Default Value
SERVER The hostname or IP address of the SNTP server