Allied Telesis SwitchBlade x3100 Series - Show Dot1 X Interface

Configuring Port Authentication Introduction
6-131
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
SHOW DOT1X INTERFACE
Syntax
SHOW DOT1X [INTERFACE={type:id-range|id-range|ifname-list|ALL}]
[FULL]
Description This command is used to display per-interface settings for 802.1X-based Port Authentica-
tion.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SHOW DOT1X INTERFACE=6.22-6.23
--- Port Authentication Interface ---
Interface Status PortControl
--------- ------------- ------------
ETH:6.22 Enabled Auto
ETH:6.23 Enabled Auto
sh dot1x interface 6.22
--- Port Authentication Interface ---
Interface............................. ETH:6.22
802.1X Authentication Status.......... Enabled
PortControl........................... Auto
ReauthEnabled......................... OFF
ReauthPeriod.......................... 3600
QuietPeriod........................... 60
ServerTimeout......................... 30
SupplicantTimeout..................... 30
ControlDirection...................... Both
EAPOLVersion.......................... 2
ReauthMax............................. 2
TxPeriod.............................. 30
EAPReqMax............................. 2
Option Description Default Value
INTERFACE The ethernet interfaces over which the DOT1X
attributes will be shown.
ALL
FULL Displays more descriptive information Abbreviated
unless only one
interface is shown.