Allied Telesis SwitchBlade x3100 Series - Switching Command List

Introduction Configuring the Forwarding Database
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
4-10
4.2.10 Switching Command List
This subsection provides an alphabetical reference for commands used to configure the Forwarding Database
(FDB). For information about spanning trees, including configuration procedures, refer to 4.5.
TABLE 4-2 Switching Commands
Commands
CLEAR SWITCH FDB (HVLAN)
CLEAR SWITCH FDB (VLAN)
DISABLE SWITCH AGEINGTIMER
DISABLE SWITCH LEARNING
ENABLE SWITCH AGEINGTIMER
ENABLE SWITCH LEARNING
SET SWITCH AGEINGTIMER
SET SWITCH MACREMOVALMODE
SHOW SWITCH
SHOW SWITCH FDB
SHOW SWITCH INTERNALMAC