CFC Media (SD Card) Introduction
1-109
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
SHOW FLASH
Syntax
SHOW FLASH [INACTCFC]
Description Displays information about the flash memory on the CFC card. Flash memory is used for
storage of user manageable files and other data not manageable by the user. The informa-
tion displayed by the SHOW FLASH command includes:
• the total size of flash memory (in kilobytes)
• the total size of free flash memory (in kilobytes)
• the total size of contiguous free flash memory (in kilobytes)
This command should not be confused with the SHOW FILES command which shows
files and memory usage associated only with user manageable file space on the flash mem-
ory.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
>SH FLASH
--- Flash Information -------------------------------------------
Total size............... 129024 kb
Free size................ 41604 kb
Contiguous free size..... 17056 kb
-----------------------------------------------------------------
>SH FLASH
<cr>
INACTCFC - This parameter is currently not supported.
>SH FLASH INACTCFC
Error: (010014): Particular command argument set not yet supported
: inactive
Option Description Default Value
INACTCFC This option is not supported in 14.2.
Note: To display the flash memory of the "inactive"
CFC, the user must first swap the active card with the
inactive one (thereby making the inactive CFC the active
CFC) and then issue the SHOW FLASH command.
N/A
To Next Page
Loading...
Need help?
General
