Example Output GE Interfaces
2-21
Software Reference for SwitchBlade x3100 Series Switches (Interface Management)
SHOW INTERFACE OPTICS
Syntax
SHOW INTERFACE [ ={ type: | type:id-range | id-range | ifname-list
| ALL } ] [ OPTICS ] [ FULL ]
Description Shows the optics data, as a subset of the data contained the SFP/XFP memory. For the
user to query the optics on an interface, the card must be operationally UP but the state
of the interface does not matter, as long as the SFP/XFP module is physically present.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
E135 - manager SEC>> SHOW INTERFACE OPTICS
--- Interface Optics ---
Port Transceiver Nominal
Interface Type Type Bit Rate Tx/Rx Power Temperature
----------- ----- ------------ ---------- ---------------- -----------
10.0 - - - -/- -
10.1 XE XFP 10000 0.5739/0.6255 30.9 C
10.2 XE XFP 10000 0.5698/0.5744 32.1 C
10.3 XE XFP 10000 0.5627/0.5619 33.2 C
11.0 XE XFP <unknown> 0.0000/0.0000 0.0 C
11.1 XE XFP 10000 0.5508/0.5579 33.3 C
11.2 XE XFP 10000 0.6016/0.3873 34.6 C
11.3 XE XFP 10000 0.5618/0.4203 32.7 C
Option Description Default Value
INTERFACE The interfaces that will have information displayed. ALL
OPTICS Shows the optics specifications
FULL Gives complete information for the interfaces specified.
To Next Page
Loading...
Need help?
General
