Configuring Port Authentication Introduction
6-133
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
SHOW TRACE AUTHDEBUG
Syntax
SHOW TRACE AUTHDEBUG [INTERFACE={type:id-range|id-range|ifname-
list|ALL}] [EVENT={{EAPOL|AUTHSERVER|ACCT} [,...]|ALL}]
Description Shows which message types are currently being traced over specified interfaces
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
SHOW TRACE AUTHDEBUG
--- Auth Debug Message Trace ---
Interface Event
--------- --------------------------------------------------------
ETH:11.19 EAPOL,AUTHSERVER,ACCT
Option Description Default Value
INTERFACE The ethernet interfaces over which the trace types will
be shown.
ALL
EVENT Specifies the type of Port Authentication trace to add:
EAPOL - The EAP messages sent and received between
the supplicant and the authenticator (SBx3112).
AUTHSERVER - The Authorization RADIUS packets
sent and received between the RADIUS server and the
authenticator (SBx3112).
ACCT - The accounting messages processed by the
RADIUS server.
ALL - All types of traces are included.
[ ,... ] Any combination of the Event types can be inserted
here, separated by a comma.
To Next Page
Loading...
Need help?
General
