EasyManuals Logo

Allied Telesis SwitchBlade x3100 Series User Manual

Allied Telesis SwitchBlade x3100 Series
940 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #832 background imageLoading...
Page #832 background image
Introduction RMON Configuration
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
7-94
• The goal of Fault Management system is to produce alarms that notify the user that a component of the
system has a fault, and to repair the fault the component longer functions and so must be fixed/replaced.
Although the goals are different, the conditions that activate each system are the same, and are labeled defects,
a condition in which there is a limited interruption of the interface to perform its function.
7.5.1.2 RMON Ethernet Statistics
The SBx3112 module collects RMON statistics for Ethernet interfaces only. These are described in Table 7-13.
(*) For the ports on the XE4 and GE cards, these statistics count both egress and ingress packets.
TABLE 7-13 RMON Statistics for Ethernet Data
Statistic Description
etherStatsDropEvents
Change alert setting for dropped packet events
etherStatsOctets
Change alert settings for octets
etherStatsPkts
Change alert setting for packets
etherStatsBroadcastPkts
Change alert setting for broadcast packets
etherStatsMulticastPkts
Change alert setting for multicast packets
etherStatsCRCAlignErrors
Change alert setting for CRC alignment errors
etherStatsUndersizePkts
Change alert settings for undersize packets
etherStatsOversizePkts
Change alert setting for oversize packets
etherStatsFragments
Change alert setting for fragmented packets
etherStatsJabbers
Change alert setting for jabbers
etherStatsCollisions
Change alert setting for packet collisions
etherStatsPkts64Octets (*)
Change alert settings for packets that are up to 64 octets long
etherStatsPkts65to127Octets (*)
Change alert settings for packets that are 65 to 127 octets long
etherStatsPkts128to255Octets (*)
Change alert settings for packets that are 128 to 255 octets long
etherStatsPkts256to511Octets (*)
Change alert settings for packets that are 256 to 511 octets long
etherStatsPkts512to1023Octets (*)
Change alert settings for packets that are 512 to 1023 octets long
etherStatsPkts1024to1518Octets (*)
Change alert settings for packets that are 1024 to 1518 octets long

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis SwitchBlade x3100 Series and is the answer not in the manual?

Allied Telesis SwitchBlade x3100 Series Specifications

General IconGeneral
BrandAllied Telesis
ModelSwitchBlade x3100 Series
CategorySwitch
LanguageEnglish

Related product manuals