Introduction Configuring the Forwarding Database
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
4-20
SHOW SWITCH FDB
Syntax
SHOW SWITCH FDB [ INTERFACE={ type:id-range | id-range | ifname-
list | ALL} ] [ ADDRESS=macaddress ] [ HVLAN={ hvlanname | vid } ]
Description Displays the contents of the Forwarding Database.
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Example
SHOW SWITCH FDB
--- Switch Forwarding Database ---
Slot VLAN Interface ID MAC Address Status
----------- ----------- --------------- ---------------------- -------
8 123 8.0 00:0C:25:04:02:F7 Dynamic
8 123 8.1 00:0C:25:04:02:F8 Dynamic
8 1 8.11 00:02:02:00:BC:57 Dynamic
8 1 8.13 00:02:02:00:AB:4E Dynamic
8 1 8.18 00:0C:25:05:20:98 Dynamic
8 1 8.19 00:0C:25:05:20:99 Dynamic
8 1 8.22 00:0C:25:05:20:9B Dynamic
11 1 11.0 00:0C:25:03:94:FC Dynamic
Option Description Default Value
INTERFACE N/A
ADDRESS A MAC address. You can use the wildcard (*) character
to filter for a range of MAC addresses
ALL
HVLAN The name of id of an HVLAN ALL
To Next Page
Loading...
Need help?
General
