Allied Telesis SwitchBlade x3100 Series User Manual

Configuring Port Authentication Introduction
6-121
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
SETDEFAULTS AUTHENTICATION INTERFACE
Syntax
SETDEFAULTS AUTHENTICATION INTERFACE={type:id-range|id-range|
ifname-list|ALL} [PORTCONTROL] [REAUTHENABLED] [REAUTHPERIOD]
[QUIETPERIOD] [SERVERTIMEOUT] [SUPPLICANTTIMEOUT]
Description This command is used to reset the specified Port Authentication interface settings to
their default. If no parameters are specified, all settings are reset. Note that when one or
of these parameters are set back to defaults on an interface, authorization on the inter-
face will drop, and any supplicants on the interface must re-authenticate.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SETDEFAULTS AUTHENTICATION INTERFACE=6.22-6.23 QUIETPERIOD
Option Description Default Value
INTERFACE The ethernet interface over which the Port Authentica-
tion settings will be set to the default(s).
ALL
PORTCON-
TROL
The authorization state of the port AUTO
REAUTHEN-
ABLED
If set to ON, the reauthentication timer (REAUTHPE-
RIOD) is activated.
OFF
REAUTHPE-
RIOD
The number of seconds that elapse before the suppli-
cant is asked to reauthenticate
3600
QUIETPE-
RIOD
The number of seconds, after a failed authentication,
that must elapse before another request can occur
60
SERVERTIME-
OUT
The number of seconds to wait for a response from a
RADIUS server before a time-out is declared.
30
SUPPLI-
CANTTIME-
OUT
The number of seconds to wait for a response from a
supplicant before a time-out is declared.
30

Allied Telesis SwitchBlade x3100 Series Specifications

General

Brand	Allied Telesis
Model	SwitchBlade x3100 Series
Category	Switch
Language	English