IGMP Counters IGMP Trace
8-25
Software Reference for SwitchBlade x3100 Series Switches (Alarms and Troubleshooting)
STOP TRACEROUTE
Syntax
STOP TRACEROUTE
Description Aborts the current TRACEROUTE command that is running on the device.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example STOP TRACEROUTE
8.6 IGMP Trace
The SBx3112 switch provides the user with the ability to display and view Internet Group Management Protocol
(IGMP) parameters. From the CLI, the user can perform the following functions in real time:
• Display reports
• Display queries
• Display events (timers, router ports, cleanup, etc.)
The user can also configure an output filter on the displays for:
• IP address (unicast client or multicast (MCAST) address)
• MAC address (unicast client or MCAST)
• Display known MCAST routers
Refer to Section 5.1 for more information.
8.6.1 IGMP Counters
The following are examples of IGMP counters for a specific card and interface.
• Example output of IGMP counters for a specified card.
officer SEC> SHOW IGMP COUNTER CARD 1
--- IGMP Card-Level Message Counters ------------------------------------------
Card Message Type Good Count Error Count
-------- -------------- -------------- --------------
5 Report 230 0
Leave 110 15
General Query 0 0
OSPF 0 0
DVMRP 0 0
PIMV1 0 0
Option Description Default Value
TRACE-
ROUTE
The current TRACEROUTE command that is running
on the device.
To Next Page
Loading...
Need help?
General
