Allied Telesis SwitchBlade x3100 Series - Create Psu

Power Management Introduction
1-211
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
CREATE PSU
Syntax
CREATE PSU={ A | B | C | D }
Description Creates the one to four PSUs for the SBx3112
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example CREATE PSU=A
Option Description Default Value
PSU The CREATE PSU command allows the user to create
POE Power Supply Units (PSUs) for preprovisioning.
The CREATE PSU command assumes that slot A and B
are for POE type PSUs, and slots C and D are for sys-
tem PSUs.
PSUs are always auto provisioned upon insertion
regardless of system provisioning mode. A single POE
PSU that is not receiving power on the back of the unit
is *not* detected as present in the shelf, because POE
power is used to detect POE presence. If a second POE
PSU is added and powered, then the first will appear as
present.