Check Software Load Introduction
1-7
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1.3.4 Check Software Load
Although the service modules are shipped with release files already present in FLASH memory, the release file
should be compared with the latest software release files that are available
Once a software release file is downloaded onto a network server, the user can copy the file to the CFC flash
file system, load it into FLASH memory, make it the active load, and ensure that when the CFC200 reboots this
latest load is always used. The user can also ensure the service module loads are obtained from the control
module.
Caution: Always check with the Allied Telesis web site to see which loads should be used so that a later load
can be downloaded if necessary. Failure to do this may result in the SBx3112 not being able to
provide all the functionality listed for a release. If you have questions, contact your Allied Telesis
representative.
Caution: If the user tries to load a software version for a card that is incompatible with the system, the card
will not go into service and an alarm/log will result.
Note: Refer to Configuring Physical Interfaces and Protocols for information on setting up the MGMT
Ethernet interface or the inband Ethernet interface to transports management data packets.
1.3.5 How to Get Command Help
Online help is available for all SBx3112 commands. There are two types of online help:
Number of MACs
on card
Number of MAC addresses available for product identification
Customer ID String to identify a customer for feature keying
Lock ID Key used for feature keying.
MGMT IP Address IP Address of Allied Telesis SwitchBlade SBx3100 product.
MGMT Subnet Mask Subnet Address. By default this is 255.255.255.0
MGMT Gateway The IP address of a gateway device, needed when connecting to an external network.
This will have a default.
MGMT Domain-
name
This is always set to a default.
MGMT DNS This is always set to a default.
Shelf Power Input Type of power supply (AC)
Provisioning Mode The system provisioning mode
ECO Mode If the Green mode for LEDs is on or off
TABLE 1-2 System Parameters for SHOW SYSTEM - SBx3112
Output Description
To Next Page
Loading...
Need help?
General
