Allied Telesis SwitchBlade x3100 Series - Show Macff

Configuring Local ARP Discard Introduction
6-177
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
SHOW MACFF
Syntax
SHOW MACFF
[ INTERFACE={ type:id-range | id-range | ifname-list | ALL } ]
[ VLAN={ vlanname-list | vid-range | ALL } ]
[ MODE={ LEARNING | LOCALARPDISCARDING } ]
Description Shows information on the MACFF configuration. The information can be filtered by
selecting specific interfaces, VLANs, or MODE.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
officer SEC>> show macff VLAN=363
--- MAC Forced Forwarding Status ---
Interface Mode VLAN Group Host Type
-------------- ------- ---- -------------------- --------------- -------
11.0 Discard 363 B 1.1.50.23 Static
11.0 Discard 363 B 1.1.50.24 Both
11.0 Discard 363 B 1.1.50.12 Dynamic
Option Description Default Value
INTERFACE
VLAN A VLAN or list of VLANs, separated by a comma
ALL - ALL VLANs that have been associated with the
group(s).
MODE
LEARNING - Allow
the exchange of messages
between the host and DCHP server(s) to result in
an IP address selected for the host,
LOCALARPDISCARDING - when an ARP packet is
to a known IP address on the same VLAN/inter-
face is dropped;