Allied Telesis SwitchBlade x3100 Series - Page 736

Introduction Configuring Local ARP Discard
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
6-176
SHOW MACFF GROUP
Syntax
SHOW MACFF GROUP={ groupname-list | ALL } [ VLAN={ vlanname-list |
vid-range | ALL } ] [ HOST={ ipaddress-list | ALL } ] [ INTERFACE={
type:id-range | id-range | ifname-list | ALL } ]
Description Shows information related to a particular GROUP. The information can be filtered by
selecting specific VLANs, host IP addresses, or interfaces.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
officer SEC>> show macff GROUP=B VLAN=363
--- MAC Forced Forwarding Status ---
Interface Mode VLAN Group Host Type
-------------- ------- ---- -------------------- --------------- -------
11.0 Discard 363 B 1.1.50.23 Static
11.0 Discard 363 B 1.1.50.24 Both
11.0 Discard 363 B 1.1.50.12 Dynamic
Option Description Default Value
GROUP A groupname or list of groupnames, separated by a
comma, or ALL groupnames that have been created.
VLAN A VLAN or list of VLANs, separated by a comma
ALL - ALL VLANs that have been associated with the
group(s).
HOST The static IP addresses that have an association with the
group(s),
ALL
INTERFACE Interfaces that are part of the group(s)
ALL -
All interfaces that have association with the
VLANs in the group(s).