Allied Telesis SwitchBlade x3100 Series - Show Dhcprelay Interface

Configuring DHCP Relay Introduction
7-43
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
SHOW DHCPRELAY INTERFACE
Syntax
SHOW DHCPRELAY INTERFACE [ ={ type:id-range | id-range | ifname-
list | ALL } ] [ FULL ]
Description Displays information about the DHCP Relay Agent for one or more interfaces. The infor-
mation includes the list of DHCP Servers as well as a list of interfaces that are configured
to run DHCP Relay.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
E135 - officer SEC>> SHOW DHCPRELAY INTERFACE=1.23
--- DHCP Interface Status (detail) ----------------------------------------
DHCP Interface Settings (ALL instances) Statistics
-------------------------------------------------- ---------------------
Interface............................. 1.23 DHCP Packet Count
Filtering............................. OFF ------------ -----
Auto Age.............................. OFF Discover.... 0
Offer....... 0
Request..... 0
Decline..... 0
Ack......... 0
Nack........ 0
Release..... 0
Inform...... 0
Option Description Default Value
INTERFACE A logical representation of one or more physical ports;
the INTERFACE to enable DHCP Relay service on.
type:id-range - the type of available ports, such as ETH
or LAG
id-range - used with type (type:id) to query the physical
ports; the numerical identifier of the interface
ifname-list - list of interface names, if not numerical
ALL - all interfaces in the system
N/A
FULL Full information is shown for the specified command
entered.