Configuring LLDP Introduction
7-83
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
ADD LLDP INTERFACE
Syntax
ADD LLDP INTERFACE={ type:id-range | id-range | ifname-list | ALL }
OPTIONS
[ PORTDESC ] [ SYSNAME ] [ SYSDESC ] [ SYSCAP ] [ PORTVLAN ]
[ VLANNAME ] [ PROTOVLAN ] [ PROTOCOL ] [ MACPHYCONFIGSTATUS ]
[ POWERVIAMDI ] [ LINKAGGREGATION ] [ MAXFRAMESIZE ] [ EPSR ]
[ UCP ] [ ALL ]
Description Adds one or more OPTIONS to the Interface(s) for LLDP. Note that this command does
not enable LDP (that is the SET LLDP INTERFACE MODE command), but adds values for
these optional parameters.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example ADD LLDP INTERFACE=0.0, 3.22 OPTIONS=EPSR
ADD LLDP INTERFACE 0.0,3.22 OPTIONS=UCP
SHOW LLDP INTERFACE=0.0
--- LLDP Information ---
Interface.......................... 0.0
Mode............................... Off
SNMP Notifications................. Disabled
TLVs Enabled for Transmit.......... UCP
Local Interface Data
Port ID......................... Interface Name:
ETH:0.1
Port Description................ ETH:0.1
............
Option Description Default Value
INTERFACE The interface where LLDP is added.
OPTIONS Refer to Table 7-11.-
To Next Page
Loading...
Need help?
General
